Related Products

SURFACE PREPARATION:
Remove any build up of dirt, grease and oil from the stained surface and ensure the area is dry.

APPLICATION:
Prior to each use mix SWEEP IT by shaking the container. Pour directly onto the stain allowing it to extend slightly beyond the area of the stain. Leave SWEEP IT to dry to a powder and then just scrape and sweep the stain away. If necessary repeat the process again. If surface appears darker after removal of SWEEP IT just increase ventilation to allow moisture to evaporate.

DRYING:
Drying time will vary depending on temperature, humidity and ventilation. Ideally the air and ground temperatures should be above13°C (55°F) with low humidity for a drying time of approx. 6-8 hours.

LIMITATIONS:
Do not apply to frozen or wet surfaces or if rain is forecast within drying time. Do not dilute. Surface and air temperatures must be at least 13°C (55°F) or higher.

COVERAGE:
3.78 L (1 US gal) will treat a stain approximately 2m2 (21sq. ft).

CLEAN UP:
Use soap and water.

KEEP OUT OF REACH OF CHILDREN
KEEP FROM FREEZING

WARRANTY:
The consumers shall satisfy themselves of the suitability of this product for the intended purpose. Weather, applicator’s skill and surface conditions are beyond manufacturer’s control. We, therefore, limit our liability to replacement of defective material only, within one year of proof of purchase.