USE Hickson Products Ltd.
USE Hickson Stamp
 

Related Products

All Purpose Cleaner

All Purpose Cleaner
Degreaser
All Purpose Cleaner
Efflorenscence Cleaner
All Purpose Cleaner
All Purpose Cleaner
All Purpose Cleaner
All Purpose Cleaner
Ultra Gloss (Waterbased)

Black Knight

Wolman

 

 

 

Instructional video (1.9MB)
Requires RealPlayer

PRODUCT USES
Stone Mason Efflorescence & Rust Remover is specially formulated to dissolve efflorescence (white mineral deposits on new stone) and remove rust stains on concrete, paving stones and brickwork without discolouring or damaging surfaces prior to the application of a sealer.

PRODUCT DESCRIPTION
Stone Mason Efflorenscence cleans evenly and enables the sealer to penetrate and seal the surface more effectively.


ADVANTAGES
· Essential prior to application of sealer
· Removes efflorescence & rust
· Brightens the colour of paving stones
· Contains no nitric acid

YOU NEED

· Eye protection
· Rubber gloves
· Long handle brush
· Mixing container
· Hose


COVERAGE
1 U.S. gallon/3.78 litres covers approximately 140 to 220 sq. ft. (13-20 m2)


WARRANTY
The consumer shall satisfy themselves of the suitability of this product for the intended purpose. Weather, applicator's skill and surface conditions are beyond manufacturer's control. We, therefore, limit our liability to replacement of defective material only, within one year of proof of purchase.

Application Guide


Important: This product applied at full strength may damage the surface. For new pavement, allow approximately 60 days for efflorescence to rise to the surface before cleaning the new pavement.

STEP #1: Prior to using EFFLORESCENCE & RUST REMOVER, remove all stains with Stone Mason - All Purpose Concrete Cleaner.

STEP #2: Avoid using EFFLORESCENCE & RUST REMOVER on dry surfaces. Wet with water before applying.

STEP #3: Dilute 3 parts water to 1 part EFFLORESCENCE & RUST REMOVER.

Application: Apply diluted product evenly onto surface, with long handle bristle brush. Let stand for four to five minutes, scrub the surface as needed, then immediately rinse thoroughly with a pressure hose until all traces of foam disappear. If any efflorescence remains on surface, repeat this process. DO NOT let EFFLORESCENCE & RUST REMOVER dry on the surface. Keep it wet at all times until it is completely rinsed off. Test small area prior to application for colour suitability.



Jump To:
Copyright © 2002, 2003 U.S.E. Hickson Products Limited