STEP #1: Thoroughly clean surface area free from all dust, dirt and other loose materials, using a wire brush if necessary. Stone Mason All Purpose Concrete Cleaner is recommended to remove oil and grease contamination.

STEP #2: If temperature is 80°F (27°C) or above, dampen area with water mist before applying.

STEP #3: Apply directly from container using a flexible putty knife, broad knife or trowel. Press firmly into patch area, smooth and feather edge. DO NOT OVER TROWEL.

STEP #4: Maximum application thickness is 1/4" (0.6cm). For repairs up to 1" (2.5 cm) deep apply in 1/4" (0.6cm) layers, allowing each layer to dry overnight. Stone Mason Vinyl Cement Patch is recommended for patches greater than 1" (2.5cm) deep or 3" (7.6cm) wide.

STEP #5: Drying time: Allow 2-3 days for light traffic. Stone Mason Vinyl Cement Patch is recommended for use in heavier vehicular traffic areas.

STEP #6: Do not apply if rain is expected within 24 hours or if temperature is expected to drop below 40°F (5°C).

STEP #7: Stone Mason Concrete Crack Filler is recommended to seal joints where joint movement is anticipated.

Clean Up: Clean hands and tools with soap and water.