|
|
|
|
PRODUCT
USES
Instant
Water Stop expands to fill cracks permanently stopping
active water leaks in concrete and masonry surfaces. Sets
in 3 to 5 minutes. Works indoors and out. |
|
|
|
YOU
NEED
· Chisel and Hammer
· Putty Knife or Trowel
· Mixing Pail
· Stir Stick
· Rubber Gloves
|
COVERAGE
1 Kg. will fill 600cc or a crack 19mm x
19mm x 1.5 metres long or 1lb. will fill 17 cubic inches or
a crack 3/4" x 3/4" x 30" long.
|
|
WARRANTY
The consumer shall satisfy themselves of the suitability of this product for
the intended purpose. Weather, applicator's skill and surface conditions are
beyond manufacturer's control. We, therefore, limit our liability to replacement
of defective material only, within one year of proof of purchase.
|
|
|
Application
Guide
|
|
Surface
Preparation: Chisel crack open to minimum 3/4"
wide by 3/4" deep, to create a greater surface
area for bonding with cement. Always undercut or cut
square and do not use a V shaped cut. Clean all loose
material from crack or hole.
Mixing:
Place a small amount of Instant Water Stop cement in
mixing pail. Add water, and mix into a putty like consistency.
Application:
Using a trowel or hand, form cement into a cone-shape.
Beginning at the top, force cement in crack and hold
in place until set.
|
|
|
