|
|
|
|
PRODUCT
USES
Stone
Mason Foundation Insulation Coating is specially designed
to coat and protect polystyrene insulation board while
adding a decorative finish. |
|
|
|
PRODUCT
DESCRIPTION
Stone Mason Instant Foundation Insulation
Coating is a fibre reinforced polymer modified, cement-based
product. Hardens to a tough, durable, U.V. protective finish.
|
YOU
NEED
· Gloves
· Mixing Pail
· Power Mixer
· Masonry Brush
· Wire Brush |
COVERAGE
50 lb. bag covers approximately 115-135
sq. feet (10.7-12.5 sq. metres) at 1/16" (.15cm) thickness. |
COLOR
Gray |
|
WARRANTY
The consumer shall satisfy themselves of the suitability of this product for
the intended purpose. Weather, applicator's skill and surface conditions are
beyond manufacturer's control. We, therefore, limit our liability to replacement
of defective material only, within one year of proof of purchase.
|
|
|
Application
Guide
|
|
Surface
Preparation:Apply only to a clean surface. For best
adhesion, the insulation board surface should be etched
with a stiff or wire brush prior to application of Stone
Mason Instant Foundation Insulation Coating.
Mixing:
Mix 50 lbs. (22.7 kg) with 1 gallon (3.78 litres) of
clean water. Mix thoroughly until a brushable consistency
is achieved and let stand for 5 minutes then remix.
Application:
Apply with a brush onto the insulation board to approximately
1/16" (.15 cm) thickness. For a thicker appearance,
and a more durable result, a second coat may be applied
after 1 hour.
Temperature:
Do not apply when temperature is expected to fall below
40°F (5°C).
Wise
Tips:
- Mix
with a power mixer to ensure a proper mix.
-
For best adhesion the insulation board surface should
be etched with a stiff or wire brush prior to application.
- Weather
should be warm and rain free for 24 hours.
|
|
|
