| :
All Surfaces must be dry and frost free. Remove any oil, grease,
rust, dirt or other contaminants that may inhibit proper adhesion.
:
Apply Fire Block Mortar
with a trowel or putty knife. Tool mortar surfaces to a smooth
defect-free finish using a slightly
wetted trowel or putty knife.
: FOR INTERIOR APPLICATION
ONLY. Not to be used in areas where there is continuous vibration
on the penetrating item. Do not expose to water. Do not install
when surface and air temperatures are below 0°C (32°F).
Do not apply to frozen surfaces. Prior to use on plastic test for
adhesion and compatibility.
:
Approx. 0.4 m2 (4 sq. ft.)
at 3 mm (1/8”) thickness.
:
Clean all equipment immediately
after use with soap and water.
: Wash thoroughly after handling.
In case of eye contact, flush immediately with water for 15 minutes
and call a physician.
:
The consumers shall satisfy themselves of the suitability
of this product for its intended purpose. Weather, applicator’s
skill and surface conditions are beyond manufacturer’s control.
We, therefore, limit our liability to replacement of defective material
only, within one year of proof of purchase.
|
