USE Hickson Products Ltd. USE Hickson Stamp
Decorative Coatings Driveway Sealers Roofing Products
 

Related Products

Airport Grade Driveway Sealer

Premium Acrylic Rejuvenator
Seal and Coat

 

 

 
PRODUCT USES
Black Knight Airport Grade Driveway Sealer is designed to be used as a premium coating for the sealing, protecting, preserving and beautifying of old and new driveways, parking lots and other asphalt surfaces such as airport aprons.

PRODUCT DESCRIPTION
Black Knight Airport Grade Sealer is a premium quality asphalt emulsion driveway sealer.


ADVANTAGES

· Airport technology brought to consumer driveways
· Three times more durable than competitive brands
· Premium protection from stains and chemical spills
· Less tracking
· Quicker drying


YOU NEED
· Crack Filler
· Pot Hole Filler
· Oil Spot Primer
· Asphalt Cleaner
· Roller or Driveway Brush


PACKAGING

Available in lithographed 17 Litre Pail.


COVERAGE

Maximum coverage 38m sq. (400 Square feet) per 17 litre pail .


WARRANTY

The consumer shall satisfy themselves of the suitability of this product for the intended purpose. Weather, applicator's skill and surface conditions are beyond manufacturer's control. We, therefore, limit our liability to replacement of defective material only, within two years of proof of purchase.

Application Guide


STEP #1: Sweep and clean entire surface. Wash with Black Knight Asphalt Cleaner or strong detergent and let dry.

STEP #2: Treat oil and chemical stains with Black Knight Oil Spot Primer.

STEP #3: Remove severely damaged areas and replace with well compacted Black Knight POT HOLE FILLER. Allow up to 90 days to harden before applying driveway sealer

STEP #4: Repair cracks with Black Knight Driveway Crack Filler.

STEP #5: Dampen surface with water and remove puddles

STEP #6: Mix thoroughly

STEP #7: Using a roller or brush, apply a thin even coat of undiluted sealer. Allow to dry a minimum of 24 hours until no longer tacky. Allow a minimum of 3 hours sunlight to cure finish.

STEP #8: If required, apply a second coat crosswise to first coat. Allow to dry between coats. Apply in dry weather with temperatures above 10°C (50°F) that will remain above 10°C (50°F) for more than 24 hours after application.



Jump To:
Copyright © 2002, 2003 U.S.E. Hickson Products Limited